User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A Switch's RJ45 Pin Assignments
User’s Manual of GS-4210 UPoE Series
4.15.3 Power over Ethernet Configuration
This section allows the user to inspect and configure the current PoE configuration setting as screen in Figure 4-16-1
appears.
Figure 4-16-1: PoE Configuration Screenshot
The page includes the following fields:
Object Description
System PoE Admin
Mode
Allows user to enable or disable PoE function. It will cause all of PoE ports to
supply or not to supply power.
PoE Management
Mode
There are six modes for configuring how the ports/PDs may reserve power and
when to shut down ports.
Consumption mode: The system offers PoE power according to PD real
power consumption.
Allocation mode: Users allow to assign how much PoE power to each port
and the system will reserve PoE power to PD.
Temperature
Threshold
Allows setting over temperature protection threshold value.
PoE Temperature
Display the PoE chip temperature
This section displays the PoE Power Usage of Current Power Consumption as Figure 4-16-2 shows.
Figure 4-16-2: Current Power Consumption Screenshot
327