User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A Switch's RJ45 Pin Assignments
User’s Manual of GS-4210 UPoE Series
4.12.8 LLDP Overloading
The LLDP Port Overloading screen in Figure 4-12-16 appears.
Figure 4-12-16 LLDP Port Overloading Table Page Screenshot
The page includes the following fields:
Object Description
Interface
The switch port number of the logical port
Total (Bytes)
Total number of bytes of LLDP information that is normally sent in a packet
Left to Send (Bytes)
Total number of available bytes that can also send LLDP information in a packet
Status
Gives the status of the TLVs
Mandatory TLVs
Displays if the mandatory group of TLVs were transmitted or overloaded
MED Capabilities
Displays if the capabilities packets were transmitted or overloaded
MED Location
Displays if the location packets were transmitted or overloaded
MED Network Policy
Displays if the network policies packets were transmitted or overloaded
MED Extended Power
via MDI
Displays if the extended power via MDI packets were transmitted or overloaded
802.3 TLVs
Displays if the 802.3 TLVs were transmitted or overloaded
306