GS-4210-Series (V2) User Manual

Command Guide of GS-4210 Series
289
Mode:
Global Configuration
Usage Guide:
Default engineid is DUT MAC address.
The configure can use ‘show snmp engineid’
Example:
The following example specifies that set remote engine id test.
Switch(config)# snmp engineid remote 192.168.1.100 112233445566
Switch# show snmp engineid
Local SNMPV3 Engine id: DEADBEEF0114
IP address Remote SNMP engineID
-------------------- ------------------------------------------------
192.168.1.100 112233445566
4.24.8 snmp host
Command:
snmp host (A.B.C.D|X:X::X:X|HOSTNAME) [(traps | informs)] [version (1|2c)] NAME
[udp-port <1-65535>] [timeout <1-300>] [retries <1-255>]
snmp host (A.B.C.D|X:X::X:X|HOSTNAME) [(traps | informs)] version 3 [(auth |
noauth | priv)] NAME [udp-port <1-65535>] [timeout <1-300>] [retries <1-255>]
no snmp host (A.B.C.D|X:X::X:X|HOSTNAME) [(traps | informs)] [version (1|2c|3)]
Parameter:
(A.B.C.D|X:X::X:X|H
OSTNAME)
Snmp trap host ipv4/ipv6 address or host name
[(traps | informs)]
Snmp notification type is traps or informs
[version (1|2c|3)]
V1/v2c/v3 traps
[(auth | noauth |
priv)]
V3 trap for auth/noauth/priv
NAME
Snmp community name or user name
[udp-port
The manage receive trap udp port num