GS-4210-Series (V2) User Manual

Command Guide of GS-4210 Series
288
AUTHPASSWD
Snmp user auth password
PRIVPASSWD
Snmp user priv password
Mode:
Global Configuration
Usage Guide:
The group version must be v3 , and the security level must match the snmp user configure.
AUTHPASSWD and PRIVPASSWD min length is 8.max length is 32 and 64
The configure can use ‘show snmp user’ to check
Example:
The following example specifies that set auth snmp user test.
Switch(config)# snmp group group3 version 3 auth read-view all write-view all
Switch(config)# snmp user user1 group3 auth md5 12345678
Switch# show snmp user
Username: user1
Password: ********
Privilege Mode: rw
Access GroupName: group3
Authentication Protocol: md5
Encryption Protocol: none
Access SecLevel: auth
4.24.7 snmp engineID
Command:
snmp engineid (default | ENGINEID)
snmp engineid remote (A.B.C.D|X:X::X:X) ENGINEID
no snmp engineid remote (A.B.C.D|X:X::X:X)
Parameter:
(default |
ENGINEID)
Default is MAC address.
ENGINEID is 10~64 hex characters
(A.B.C.D|X:X::X:X)
Host ipv4/ipv6 address