GS-4210-Series (V2) User Manual

Command Guide of GS-4210 Series
28
Parameter:
<1-10>
Specify the maximum request retries.
Default:
2 times
Mode:
Interface Configuration
Usage Guide:
Use the “dot1x max-req” command to configure the maximum request retries. Use the no form of this command to
restore the period to default value.
Example:
The example shows how to configure maximum request retries to 4 times on port 1.
switch(config)# interface gi1
switch(config-if)# dot1x max-req 4
switch(config-if)# exit
switch(config)# show dot1x interfaces gi1
Port | Mode | Current State | Reauth Control | Reauth Period
--------+--------------------+----------------------+---------------------+-----------------
gi1 Authentication | Initialize | Enabled | 3600
Quiet Period: 60 Seconds
Supplicant Timeout: 30 Seconds
Max req: 4
Session Time (HH:MM:SS): 0: 0: 0: 0
4.1.8 dot1x guest-vlan
Command:
dot1x guest-vlan <1-4094>
no dot1x guest-vlan
Parameter:
<1-4094>
Specify VLAN ID to enable 802.1X guest VLAN.
Default:
Default is disabled