GS-4210-Series (V2) User Manual

Command Guide of GS-4210 Series
228
Switch(config-mld-profile)#exit
Switch(config)# exit
Switch# show ipv6 mld profile
IPv6 mld profile index: 1
IPv6 mld profile action: permit
Range low ip: ff13::1
Range high ip: ff13::10
IPv6 mld profile index: 5
IPv6 mld profile action: deny
Range low ip: ff12::1
Range high ip: ff12::12
4.17.10 ipv6 mld filter
Command:
ipv6 mld profile <1-128>
profile range ipv6 <ipv6-addr> [ipv6-addr] action (permit | deny)
show ipv6 mld profile [<1-128>]
Parameter:
<1-128>
specifies profile ID
[interfaces
IF_PORTS]
Specifies interfaces to display
Mode:
Interface mode
Usage Guide:
After create ipv6 mld profile entry. Can use ‘ipv6 mld filter 1’ to bind a profile for port.
When then port bind a profile. Then the port learning group will update, if the group is not match the profile rule it will
remove the port from the group. Static group is excluded.
The configure can use ‘show ipv6 mld filter ’ to display
Example:
This example shows how to set ipv6 mld filter