GS-4210-Series (V2) User Manual

Command Guide of GS-4210 Series
205
no logging <ip-addr>
Parameter:
ip-addr
Specify the IP address of remote logging server.
port
Specify the port number of remote logging server.
severity
Specify the minimum severity mask of logging message.
facility
Specify the facility of logging messages.
Default:
Port = 514,
Severity = 6 (emerg, alert, crit, error, warning, notice, info)
Facility = Local7
Mode:
Global Configuration
Usage Guide:
Enable/Disable the capability to log message to the remote syslog server.
logging host 192.168.1.100
Enable the capability to log messages to the remote server. The default values of the parameter port is “514”, severity
is “6” (emerg, alert, crit, error, warning, notice, info), and the facility is “local7”. All logging message will be sent to the
remote server. Only when the remote logging capability is enabled, the status of remote logging service will be shown
by the command “show logging”. When an existed entry is set twice, the old setting will be replaced and modified with
the new one.
no logging host 192.168.1.100
Disable the capability to log messages to the remote server. When the remote logging service is disabled, the log will
not be sent to the remote syslog server, and the status of remote logging entry will be removed from service list
shown by the command “show command”.
show logging
Display the logging status. It will show the logging configuration of the system, including the global logging status, and
the lists of logging services. When the remote logging capability is enabled, the status of remote logging will be
shown by the command “show logging”; Otherwise, the remote logging entry will be removed from the service list.
Example:
Switch(config)# logging host 192.168.1.100
Switch(config)# logging host 192.168.1.100 port 2048 severity 3 facility local1