GS-4210-Series (V2) Quick Guide

10
5.1 Logging on to Console
Once the terminal is connected to the device, power on the Managed Switch and
the terminal will display “running testing procedures”. Then, the following message
asks to log in user name and password. The factory default user name and
passwordareshownasfollows,andtheloginscreeninFigure5-3appears.
Username:admin
Password:admin
Figure 5-3: Managed Switch Console Login Screen
The user can now entercommands to manage theManaged Switch. Fora detailed
description of the commands, please refer to the following chapters.
Note
1.For security reason, please change and memorize the new pass-
word after this first setup.
2. Only accept command in lowercase letter under console interface.
5.2 ConguringIPAddress
TheManagedSwitchisshippedwithdefaultIPaddressasfollows:
IPAddress:192.168.0.100
SubnetMask:255.255.255.0