GS-4210 Series User Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A Switch's RJ45 Pin Assignments
User’s Manual of GS-4210 Series
4.9.5 Access
This section is to control the access of the Managed Switch, including the different access methods – Telnet, SSH, HTTP and
HTTPs.
4.9.5.1 Telnet
The Telnet Settings and Information screen in Figure 4-9-21 and Figure 4-9-22 appear.
Figure 4-9-21 Telnet Settings Screenshot
The page includes the following fields:
Object Description
Telnet Service
Disable or enable telnet service
Login Authentication List
Select login authentication list from this drop-down list
Enable Authentication List
Select enable authentication list from this drop-down list
Session Timeout
Set the session timeout value
Password Retry Count
Set the password retry count value
Silent Time
Set the silent time value
Buttons
: Click to apply changes
: Click to disconnect telnet communication
239