GS-4210-Series (V2) User Manual

User’s Manual of GS-4210 Series
341
The page includes the following fields:
Object Description
• PoE Mode
There are three modes for PoE mode.
 Enable: enable PoE function.
 Disable: disable PoE function.
 Schedule: enable PoE function in schedule mode.
• Schedule
Indicates the scheduled profile mode. Possible profiles are:
 Profile1
 Profile2
 Profile3
 Profile4
• Force Power
Provide to disable or enable PoE Force mode.
The force power function will directly deliver power over UTP cable.
Please be careful when using force power function and make sure the remote
device is PoE powered device (PD).
• Extended Mode
Provide to disable or enable PoE extended mode.
• Priority
The Priority represents PoE ports priority. There are three levels of power priority
named Low, High and Critical.
The priority is used in case the total power consumption is over the total power
budget. In this case the port with the lowest priority will be turned off, and offer
power for the port of higher priority.
• PD Class
Displays the class of the PD attached to the port, as established by the
classification process. Class 0 is the default for PDs. The PD is powered based
on PoE Class level if the system is working in Classification mode.
• Current Used [mA]
The Power Used shows how much current the PD currently is using.
• Power Used [W]
The Power Used shows how much power the PD currently is using.
• Power Allocation [W]
It can limit the port PoE supply watts. Per port maximum value must be less
than 30 watts. Total port values must be less than the Power Reservation value.
Once power overload is detected, the port will auto shut down and keep in
detection mode until PD’s power consumption is lower than the power limit
value.
Buttons
: Click to apply changes.