User Manual

#Notice:
Please refers to APPENDIX-A for detailed wiring information of the Managed Media Converter.
To prevent from optic acceptor malfunction, check the both wires / transmitter before power on the
converter.
 FT-905A Installation
FT-905A is with high reliability and flexibility to extend the distance from 2km to 60km. It depends on the MFB family Fast
Ethernet SFP modules. The SFP transceivers are hot-plug and hot-swappable. You can plug-in and out the transceiver
to/from any SFP port without having to power down the Managed Media Converter.
To install FT-905A with 100Base-SFP, simply complete the following steps:
Step 1: Precede with the steps 4 and steps 5 of session 2.2.1 Stand-alone Installation to connect the network cabling
and supply power to your Managed Media Converter.
Step 2: Slot in the 100Base-FX SFP. Make sure both side of the SFP transfer are with the same media type, for example:
100Base-FX/2km to 100Base-FX/2km, 100Bas-FX/60km to 100Base-FX/60km.
Step 3: Connect the fiber cable. Attach the duplex LC connector on the network cable into the SFP transceiver
#Note:
It recommends using PLANET MFB family Fast Ethernet SFP modules on the Managed Media
Converter. If you insert a SFP transceiver that is not supported, the Managed Media Converter will
not recognize it.
-6-