User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
68
4.3.3 PoE Port Sequential
This page allows the user to configure the PoE Ports started up interval time as the PoE Port Sequential configuration screen in
Figure 4-3-5 appears.
Figure 4-3-5: PoE Port Sequential Configuration Page Screenshot
The page includes the following fields:
Object Description
• Port Selection Select specific PoE port for further configuration.
• State Enable or disable specific PoE Port sequential function.
• Delay xxx Seconds
•
(Max. 300)
This column allows user to configure the PoE Port Start Up interval time.
Delay time range is from 1 seconds to 300 seconds.
• Port Display per PoE port list.
• State Display per PoE port operation status.
• Delay Time (Seconds) Display per PoE port delay time (seconds) setting.
Buttons
: press this button to take effect.
: press this button to refresh information.