User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
59
4.2.5 NTP Settings
On this page. NTP, an acronym for Network Time Protocol, is for synchronizing the clocks of computer systems. NTP uses
UDP (data grams) as transport layer. You can specify NTP Servers and set GMT time zone. The NTP configuration screen in
Figure 4-2-12 appears.
Figure 4-2-12: NTP Settings Configuration Page Screenshot
The page includes the following fields:
Object Description
• System Time
Display current system time of Managed PoE+ Switch.
• State
Indicates the NTP mode operation. Possible modes are:
Enable: Enable NTP mode operation. When enable NTP mode operation, the
agent forward and to transfer NTP messages between the clients and the
server when they are not on the same subnet domain.
Disable: Disable NTP mode operation.
• Time Zone
Allow selecting the time zone according to current location of Managed PoE+
Switch.
• Primary Server IP
Configure the NTP server IPv4 IP address on this page.
• Secondary Server IP
Configure the NTP server IPv4 IP address on this page.
Button
: press this button to take effect.