User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
193
6.10 Restart Command
Command List:
restart re-start command, key in '?' to show the list
igmp_snooping Used to restart IGMP process.
link_aggregation Used to restart link aggregation process.
mcp Used to restart MCP process.
mld_snooping
Used to restart MLD process.
stp Used to restart STP process .
syslog Used to restart syslog function.
6.11 Save Command
Command List:
6.12 Show Command
Command List:
save save setting of Managed PoE+ Switch.
show Show command, key in '?' to show the list
account
Used to show account information.
acl Used to show information of ACL.
bandwidth_ctrl Used to show the information of bandwidth control.
cos
Used to show cos function information.
DHCP Snooping Used to show information of DHCP Snooping.
dhcprelay
Used to show information of dhcprelay.
double-vlan Used to show information of double VLAN.
gvrp
Used to show gvrp status information.
igmp_snooping Used to show information of IGMP snooping.
imp_table Used to show information of IMP-table.
ip Used to show the information of IP.
ipv6 Used to show the information of IPv6.
link_aggregation Used to show information of link aggregation.
lldp Used to show information of LLDP.
loop-detect Used to show loop detect status information .