User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
192
6.7 Enable Command
Command Lists:
6.8 Exit Command
Command List:
6.9 Reboot Command
Command List:
enable enable command, key in '?' to show the list
DHCP_arp_inspection Used to enable DHCP Dynamic ARP Inspection function.
DHCP_mac_verification
Used to enable DHCP MAC verification function.
DHCP_snooping Used to enable DHCP Snooping function.
dhcprelay
Used to enable dhcprelay function.
gvrp
Used to enable gvrp function.
igmp_snooping Used to enable IGMP snooping function.
imp_table Used to enable IMP-table function.
lldp
Used to enable LLDP function.
loop-detect Used to enable loop detect protocol.
mac_table Used to enable MAC-table function.
mirror
Used to enable mirror in standard mode.
mld_snooping
Used to enable MLD snooping.
neighbor Used to enable neighbor MACID function.
ntp
Used to enable network time protocol function.
poe
Used to enable poe ports.
snmp
Used to enable SNMP protocol.
storm_ctrl Used to enable storm control function.
stp
Used to enable STP function.
stp-loop-detect Used to enable STP loop detect protocol.
syslog Used to enable syslog function.
vlan Used to enable VLAN function.
exit Exit this CLI session.
reboot Reboot the Managed PoE+ Switch.