User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
190
6.3 Create Command
Command Lists:
6.4 Default Command
Command Lists:
neighbor
Used to config neighbor MACID information.
ntp Used to config the attributes of ntp.
poe
Used to config poe.
ports Used to config the attributes of ports.
qosaging
Used to config Qos aging.
qosmode
Used to config Qos function.
qosremap
Used to config Qos remap function.
snmp
Used to config snmp information.
storm_ctrl Used to config storm control.
stp Used to config STP.
stp-loop-detect Used to config STP loop detect information.
syslog
Used to config syslog.
system
Used to config system information.
vlan Used to config VLAN.
voice-vlan Used to config voice VLAN.
create create command, key in '?' to show the list
acl Used to create a new profile of ACL.
igmp_snooping
Used to create a new entry of IGMP snooping.
imp_table Used to create a new entry of IMP-table.
mac_table Used to create a new entry of MAC-table.
mld_snooping Used to create a new entry of MLD snooping.
snmp
Used to create snmp information.
stp Used to create a new entry of STP.
vlan Used to create a new entry of VLAN.
default default command, key in '?' to show the list
all Load factory default .