User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
189
6.1 Clear Command
Command Lists:
clear clear command, key in '?' to show the list.
acl Used to clear ACL table.
igmp_snooping Used to clear entries of IGMP snooping.
ip Used to clear IPv4 settings.
ipv6 Used to clear IPv6 settings.
mac_table Used to clear dynamic entries of MAC-table function by port.
mib_counter Used to clear MIB counters.
mld_snooping Used to clear entries of MLD snooping.
poe Used to clear poe informations.
syslog Used to clear server information of syslog.
system Used to clear system information.
vlan Used to clear entry of protocol VLAN.
6.2 Config Command
Command Lists:
config config command, key in '?' to show the list
account
Used to config account information.
acl Used to config ACL.
bandwidth_ctrl Used to set the bandwidth parameters of ports.
cos
Used to config cos function.
dhcprelay
Used to config dhcprelay.
double-vlan Used to config double VLAN.
gvrp
Used to config gvrp information.
igmp_snooping Used to config IGMP snooping.
imp_table Used to config IMP-table.
ip Used to config IP information.
ipv6 Used to config IPv6 information.
link_aggregation Used to config link aggregation.
lldp Used to config LLDP.
loop-detect Used to config loop detect information.
mac_table Used to config MAC-table.
mirror Used to set mirror port function and method.
mld_snooping Used to config MLD snooping.