User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
174
4.9.10.2 LLDP Port Setting
This page allows you to configure the LLDP Port settings for Managed PoE+ Switch as the screen in Figure 4-9-33 appears.
Figure 4-9-33: LLDP Port Settings Configuration Page Screenshot
The page includes the following fields:
Object Description
• Port Selection This column provides selecting specific port for LLDP Port Settings function.
• Admin Status
This column provides displaying and selecting the Admin status of LLDP and
the available options are :
Disable
The Managed PoE+ Switch will not send out LLDP information, and will drop
LLDP information received from neighbors.
Rx Only
The Managed PoE+ Switch will not send out LLDP information, but LLDP
information from neighbor units is analyzed.
Tx Only
The Managed PoE+ Switch will drop LLDP information received from
neighbors, but will send out LLDP information.
Tx & Rx
The switch will send out LLDP information, and will analyze LLDP information
received from neighbors.
• Port Description
This column provides displaying and configuring enable or disable the Port
Description function.
When enabling the "Port Description", the LLDP information will be transmitted.