User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
147
4.9.1.6 STP Loop Detect Settings
This page allows you to configure the STP Loop Detect settings for Managed PoE+ Switch as the screen in Figure 4-9-10
appears.
Figure 4-9-10: STP Loop Detect Settings Configuration Page Screenshot
The page includes the following fields:
Object Description
STP Loop Detect Setting
• SFP Loop Detection State
This column provides configuring enable or disable the SFP Loop Detection
State function on specific port; the default mode is Enable.
• Block Release Time
This column providesconfiguring the Block Release Time settings; the
available range is 1 to 255.
Loop Detect Port State
• Port Display per port list.
• State Display per port state information.
Buttons
: press this button to take effect.
: press this button to refresh current status.