User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
145
4.9.1.4 STP Instance Settings
This page allows you to configure the STP Instance settings for Managed PoE+ Switch as the screen in Figure 4-9-8 appears.
Figure 4-9-8: STP Instance Settings Configuration Page Screenshot
The page includes the following fields:
Object Description
• MSTI ID This column provides configuring the MSTI ID settings.
• Priority This column provides configuring the Priority settings and the available range is
0
to
61440
.
• Instance Type Display the instance type information.
• Instance Priority Display the instance priority information.
• Action
: press this button to edit specific Instance ID Settings.
: press this button to view STP Instance operational status.
STP Instance Operational Status
• MSTP ID Display MSTP ID information.
• External Root Cost Display External Root Cost information.
• Internal Root Cost Display Internal Root Cost information.
•
Root Port
Display Root Port information.
• Forward Delay Display Forward Delay information.
• Designated Root Bridge Display Designated Root Bridge information.
• Regional Root Bridge Display Regional Root Bridge information.
• Designated Bridge Display Designated Bridge information.
•
Max. Age
Display Max. Age information.
• Max. Hops Display Max. Hops information.
Button
: press this button to take effect.