User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
142
4.9.1.2 STP Port Settings
This page allows you to configure the STP Port settings for Managed PoE+ Switch as the screen in Figure 4-9-6 appears.
Figure 4-9-6: STP Port Settings Configuration Page Screenshot
The page includes the following fields:
Object Description
• Port Selection Select specific port for further configuration.
• State This column provides configuring enable or disable the spanning tree function
on specific port; the default mode is Disable. Also display current status of per
port.
• Edge Port This column provides configuring enable or disable the Edge Port function on
specific port; the default mode is Disable. Also display current status of per port.
• BPDU Protect This column provides configuring enable or disable the BPDU Protect function
on specific port; the default mode is Disable. Also display current status of per
port.
• Root Protect This column provides configuring enable or disable the Root Protect function on
specific port; the default mode is Disable. Also display current status of per port.
• Loop Protect This column provides configuring enable or disable the Loop Protect function on
specific port; the default mode is Disable. Also display current status of per port.
•
Port
Display per port list.