User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
129
4.8.2.3 DHCP Snooping Entry Setting
This page allows you to configure the DHCP Snooping Entry settings for Managed PoE+ Switch as the screen in Figure 4-8-5
appears.
Figure 4-8-5: DHCP Snooping Entry Setting Configuration Screen Page Screenshot
The page includes the following fields:
Object Description
DHCP Snooping Configure
• DHCP Snooping This column provides configuring enable or disable the DHCP snooping function.
The DHCP Snooping is used to block intruder on the untrusted ports of DUT when it
tries to intervene by injecting a bogus DHCP reply packet to a legitimate conversation
between the DHCP client and server.
• ARP Inspection This column provides configuring enable or disable the ARP inspection function.
The ARP Inspection is a secure feature. Several types of attacks can be launched
against a host or devices connected to Layer 2 networks by "poisoning" the ARP
caches. This feature is used to block such attacks. Only valid ARP requests and
responses can go through DUT.
• MAC Verification This column provides configuring enable or disable the MAC vertification function.
Snooping Table
• Port Display the port information.
• IP Display the IPv4 or IPv6 address.
• MAC
Display the MAC information.
• Leave Time Display the leave time information.
• Action
: press this button to edit specific DHCP Snooping Entry setting.
: press this button to delete DHCP Snooping Entry setting.
Button
: press this button to take effect.