User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
109
4.7.2 ACL Profile List
This page allows you to configure the ACL Profile List settings for Managed PoE+ Switch as the ACL Profile List screen in
Figure 4-7-2 appears.
Figure 4-7-2: ACL Profile List Configuration Page Screenshot
The page includes the following fields:
Object Description
• User Entries
Display the amount of entry occupied by rules that has been set up successfully,
with a maximum of 128. It is not a rule that takes up an entry; the number of entry
occupied by a rule is automatically calculated according to the setting.
• Profile Name
Display and configure the name of a specific ACL Profile; the maximum length is
20 characters.
• Type
Indicates the frame type of the ACL Profile. Possible values are:
MAC: The ACL will match the MAC address.
IP: The ACL will match all IPv4 frames.
IP_Ext: The ACL will match all IPv4 frames with VID/CoS/TCP Flag/ DSCP/IP
protocol.
IPv6: The ACL will match all IPv6 standard frames.
Advanced: The ACL will match all MAC address and IPv4 frames with
VID/CoS/TCP Flag/ DSCP/IP protocol.
• Action
Indicates the forwarding action of the ACL Profile.
: press this button to edit the specific ACL Profile.