User Manual

15
Step 5: After the brackets are attached to the FGSW-2511P, use suitable screws
to securely attach the brackets to the rack, as shown in Figure 3-2.
1 3 5 7 9 11 13 17 19 2115 23 25
GigabitPWR
2 4 6 8 10 12 14 18 20 2216 24
PoE
FGSW-2511P
Standard
QoS
Extend
VLAN
24-Port 10/100X
802.3a
t PoE
+
1-Port Gigabit TP/SFP Combo Ethernet Switch
1 3 5 7 9 11 13 17 19 2115 23
2 4 6 8 10 12 14 18 20 2216 24
25
10/100/1000T
1000X
25
ACTLNK
PoE-in-Use
Figure 3-2: Mounting the FGSW-2511P in a Rack
Step 6: Connect your FGSW-2511P to 802.3af/802.3at complied power devices
(PDs) and other network devices.
 Connect one end of a standard network cable to the 10/100BASE-TX RJ45
ports on the front panel of the FGSW-2511P.
 Connect the other end of the cable to the PoE PD devices such as PoE IP
cameras, PoE wireless Access points, PoE VoIP Phones, etc.
Note
Connection to the Switch requires UTP Category 5e, 6 network
cabling with RJ45 tips.
Step 7: Supply power to the FGSW-2511P.
 Connect one end of the power cable to the FGSW-2511P.
 Connect the power plug of the power cable to a standard wall outlet.
When the FGSW-2511P receives power, the Power LED should remain solid Green.