Datasheet

ManualsBrandsPLANET Technology ManualsPower over Ethernet24-Port 10/100TX 802.3at PoE + 2-Port 10/100/1000T + 1-Port Shared 1000X SFP Desktop Switch (185 Watts)

FGSD-2621P

Cost-optimized, Multi-mode Ethernet Switch for PoE Networking

To facilitate 32W PoE power network applications with the transmission, PLANET

FGSD-2621P is equipped with 24 10/100BASE-TX Fast Ethernet ports, 2 extra

Gigabit TP ports and 1 1000BASE-X SFP combo interface ideally suitable for

centralized power management. With a total of 185 watts of PoE budget, it

features high-performance Gigabit uplink and IEEE 802.3at PoE+ (up to 32W)

capabilities.

24-Port 10/100TX 802.3at PoE + 2-Port 10/100/1000T +

1-Port Shared 1000X SFP Desktop Switch

Physical Port

• 24 10/100BASE-TX RJ45 ports with IEEE 802.3at PoE+

injector function (ports 1~24)

• 2 10/100/1000BASE-T Gigabit RJ45 ports (ports 25~26)

• 1 1000BASE-X SFP interface (port 26)

Power over Ethernet

• Complies with IEEE 802.3at Power over Ethernet Plus end-

span PSE

• Up to 24 ports of IEEE 802.3af/802.3at devices powered

(ports 1~24)

• Supports PoE power up to 32 watts for each PoE port,

with a total PoE budget of 185W.

• Each port supports 55V DC power to PoE powered device.

• Auto detects powered device (PD)

• Supports PD alive function.

• Circuit protection prevents power interference between

ports.

• Remote power feeding up to 100m in standard mode with

250m in extend mode

Switching

• Hardware-based 10/100Mbps and 10/100/1000Mbps auto-

negotiation and auto MDI/MDI-X

• SupportsIEEE802.3xowcontrolinfull-duplexmodeand

backpressure in half-duplex mode

• Integrates address look-up engine, supporting 16K absolute

MAC addresses

• 16K jumbo frame supports 1000Mbps speed

• Hardware-based DIP switch for Standard, VLAN or Extend

mode selection;

– VLAN mode: Ports 1 to 24 cannot communicate with

each other, but can communicate with the uplink ports

25 to 26 and SFP port 26.

– Extend mode: Ports 1 to 8 have data rate of 10Mbps.

The farthest transmission distance is up to 250 meters

and all ports can communicate with each other.

• VLAN mode is to isolate ports to prevent broadcast storm

anddefendDHCPspoong

• Automatic address learning and address aging

• SupportsEnergy-EfcientEthernet(EEE)function(IEEE

802.3az)

Two Gigabit Uplink Ports

The FGSD-2621P provides two extra Gigabit TP ports and one 1000BASE-X

SFP combo interface that enable the network administrators to increase their

network bandwidth to relieve traffic congestion when the two 10/100/1000BASE-T

or one w1000BASE-X uplink port are used to connect devices, such as NVR, video

streaming server, NAS and more. With the combo design, the administrators can

easily connect network devices no matter how large the network expansion is.

Perfect Integrated Solution for PoE IP Surveillance

The FGSD-2621P brings you an ideally secure surveillance system at a lower total

cost. The FGSD-2621P provides 24 10/100Mbps 802.3at PoE+ ports able to feed

sufficient PoE power to 24 IEEE 802.3af/IEEE 802.3at PoE+ IP cameras at the

same time. It is also able to connect with one 24-channel NVR or three 8-channel

NVRs, uplinked to backbone switch and the monitoring center. With such a high-

performanceswitcharchitecture,therecordedvideolesfromthePoEIPcameras

can be saved to the NVR system where the administrator can control and monitor

the surveillance images in both the local LAN and remote sites.

Summary of content (6 pages)

PAGE 1
FGSD-2621P 24-Port 10/100TX 802.3at PoE + 2-Port 10/100/1000T + 1-Port Shared 1000X SFP Desktop Switch Physical Port • 24 10/100BASE-TX RJ45 ports with IEEE 802.3at PoE+ injector function (ports 1~24) • 2 10/100/1000BASE-T Gigabit RJ45 ports (ports 25~26) • 1 1000BASE-X SFP interface (port 26) Power over Ethernet • Complies with IEEE 802.
PAGE 2
FGSD-2621P Hardware Power Upgrade • 11-inch desktop size, 1U height. • LED indicators for system power, per port PoE ready and 802.3at 30.8W PoE activity, speed, link/act Door Phone Video Phone PTZ Camera WiMAX AP/CPE Thin Client • 1 silent fan to provide stable and efficient power performance • Supports contact discharge of ±6KV DC and air distance 802.3af discharge of ±8KV DC for Ethernet ESD protection 15.
PAGE 3
FGSD-2621P Powered Device Alive Check The FGSD-2621P adopts not only Power over Ethernet technology, but also automated PD monitoring and real-time PoE status. The PD alive check feature is applied in Standard, VLAN and Extend modes. After the PoE of the port is powered on, the device starts to detect whether the port is transmitting data. If the port does not transmit data and the duration exceeds a specific time, PoE will automatically power off and then re-power.
PAGE 4
FGSD-2621P Department / Workgroup PoE Network Providing 24 PoE in-line power interfaces, the FGSD-2621P can easily build a power that can centrally control IP phone system, IP camera system and wireless AP group for the enterprise. Cameras can be installed around the corner in the company or campus for surveillance demands. Without the powersocket limitation, the FGSD-2621P makes the installation of cameras easier and more efficient. 802.
PAGE 5
FGSD-2621P Specifications Model FGSD-2621P Hardware Specifications Fast Ethernet Copper Ports Gigabit Ethernet Copper Ports Gigabit SFP Ports 24 x 10/100BASE-TX RJ45 auto-MID/MDI-X Port Supports IEEE 802.
PAGE 6
FGSD-2621P Ordering Information FGSD-2621P 24-Port 10/100TX 802.3at PoE + 2-Port 10/100/1000T + 1-Port Shared 1000X SFP Desktop Switch Related PoE Products FGSD-1821P 16-Port 10/100TX 802.