User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
93
4.5.7 Protocol VLAN Config
This page is used for configuring the Managed PoE+ Switch Protocol VLAN Config as the Protocol VLAN Config screen in
Figure 4-5-7 appears.
Figure 4-5-7 : Protocol VLAN Config Configuration Page Screenshot
The page includes the following fields:
Object Description
• Protocol VLAN Enable
Click to activate the Protocol VLAN settings.
• Enable
Select the number of groups to enable.
• No.
Display the groups number.
• VID
Set the VID value and when the packet conforms to the set protocol on this web
page, the VLAN member is queried with VID.
• Protocol Type
Set protocol type.
• Protocol Select
Select the Protocol and the available options are shown below:
Ether Type:
The set value of the protocol type must be greater than 0x0600 when setting
Ether Type. Its format is DA+SA+Protocol type.
LLC: Its format is DA+SA+Protocol Type.
RFC1042: Its format is DA+SA+length+AAAA03+000000+Protocol Type.
Button
: press this button to take effect.