User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
86
4.5.4 VLAN Group-based Entry Config
Adding Static Members to VLANs (VLAN Index)
Use the VLAN Group Member Port to configure port members for the selected VLAN index. The VLAN Group-based Entry
Config configuration can be monitored and modified here. Up to 26 VLANs are supported. This page allows for adding and
deleting VLANs as well as adding and deleting port members of each VLAN as the VLAN Group-based Entry Config screen in
Figure 4-5-3 appears.
Figure 4-5-3: VLAN Group-based Entry Config Configuration Page Screenshot
The page includes the following fields:
Object Description
• Group Name
Configure the Managed PoE+ Switch per VLAN group name information on this
web page; the maximum length is 20 characters.
• Group Member Port
Assign specific port to per VLAN group.
: press this button to create a new specific VLAN group.
: press this button to modify a specific VLAN group.
Group Table
• Group Name
Display the current group name of VLAN group.
• Group Member Port
Display the current group member port number of VLAN group.
• Action
: press this button to edit specific VLAN group.
: press this button to delete specific VLAN group.