User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
78
4.4.4 Bandwidth Control
This page allows you to configure the incoming and outgoing bandwidth control settings for all switch ports as the bandwidth
control screen in Figure 4-4-6 appears.
Figure 4-4-6: Bandwidth Control Configuration Page Screenshot
The page includes the following fields:
Object Description
• Port Selection Select specific port for incoming and outgoing bandwidth control settings.
• Ingress Rate (kbps)
•
(1-1000000)
Controls the rate (unit: kbps) for the ingress rate. This value is restricted to
1-1000000. The default value is
Unlimited
.
• Egress Rate (kbps)
• (1-1000000)
Controls the rate (unit: kbps) for the egress rate. This value is restricted to
1-1000000. The default value is Unlimited.
• Port Display per port list.
• Ingress Rate (kbps) Display per port ingress rate setting value.
• Egress Rate (kbps) Display per port egress rate setting value.
Buttons
: press this button to take effect.
: press this button to refresh information.