User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
72
4.4.1 Port Configuration
This page displays current port configurations and each port can also be configured here as the Port configuration screen in
Figure 4-4-2 appears.
Figure 4-4-2 : Port Configuration Page Screenshot
The page includes the following fields:
Object Description
• Port Selection Select specific port for further configuration.
• State Enable or disable specific Port function.
• Speed/Duplex Change specific Port speed duplex and the available optios are shown below:
Top Speed/10M Half/10M Full/100M Half/100M Full/1000M Full.
• Auto Negotiation Enable or disable auto negotiation function on specific Port.
• Flow Control Enable or disable flow control function on specific Port.
• Address Learning Enable or disable address learning function on specific Port.
• Name Configure the Managed PoE+ Switch per port description information on this
page; the maximum length is 20 characters.
• Port Display per port list.
Setting
• State Display per port current operation setting mode.
• Speed/Duplex Display per port current speed/duplex setting mode.