User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
67
System is going to check the PD again according to the reboot time. If ou can
not make sure precisely booting time, we suggest you to set it longer.
Port Settings
• Port
Select specific PoE port for further configuration and list all ports on this page.
• State
Enable or disable specific PoE port PoE Alive Check function and display
current status of eachPoE port.
• IP of Device to Check
This column allows user to set PoE device IP address here for system making
ping to the PoE device. Please be noticed that the PD’s IP address must be set
to the same network segment with Managed PoE+ Switch.
Also display current setting of eachPoE port.
Buttons
: press this button to take effect.
: press this button to refresh information.