User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
63
4.2.9 Firmware Update
This page facilitates an update on the firmware controlling the switch as the Web Firmware Upgrade screen in Figure 4-2-17
appears.
Figure 4-2-17: Web Firmware Update Page Screenshot
To open Firmware Upgrade screen, perform the following:
1. Click System -> Firmware Upgrade.
2. Click the “ “button of the Main Page, the system would pop up the file selection menu to choose firmware.
3. Select on the firmware then click “ ”, the Software Upload Progress would show the file with upload
status.
4. Once the software is loaded to the system successfully, the following screen appears. The system will load the new
software after reboot.
DO NOT Power OFF the Managed PoE+ Switch until the update progress is complete.