User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
40
3.6 PLANET Smart Discovery Utility
For easily listing the Managed PoE+ Switch in your Ethernet environment, the PLANET Smart Discovery Utility is an ideal
solution. The following installation instructions are to guide you to running the PLANET Smart Discovery Utility.
1. Deposit the PLANET Smart Discovery Utility in administrator PC.
2. Run this utility as the following screen appears.
Figure 3-6: Planet Smart Discovery Utility Screen
If there are
two LAN cards or above in the same administrator PC, choose different LAN card by
using the “Select Adapter” tool.
3. Press “Refresh” button for the currently connected devices in the discovery list as the screen shows below:
Figure 3-7: Planet Smart Discovery Utility Screen