User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
27
FGSW-2624HPS and FGSW-2624HPS4 LED Indication
Figure 2-2: Managed PoE+ Switch Series LEDs on Front Panel
System
LED
Color
Function
PWR Green Lights to indicate the Switch has power.
SYS Green
Lights to indicate the system is working.
Off to indicate the system is booting.
Per 10/100Mbps port with PoE interfaces (Port-1 to Port-24)
LED Color Function
LNK/ACT Green
Lights Indicates the link through that port is successfully established at 10/100Mbps.
Blink Indicates the Switch is actively sending or receiving data over that port.
PoE-in-Use Amber
Lights Indicates the port is providing PoE power.
Off Indicates the port is not providing PoE power.
Per 10/100/1000Mbps RJ45 Combo Interface (Port-25 to Port-26)
LED Color Function
1000
LNK/ACT
Green
Lights Indicates the port is successfully established.
Blink Indicates the Switch is actively sending or receiving data over that port.
10/100
LNK/ACT
Amber
Lights Indicates the port is successfully established.
Blink Indicates the Switch is actively sending or receiving data over that port.
Per 1000Mbps SFP Combo Interface (Port-25 to Port-26)
LED
Color
Function
1000
LNK/ACT
Green
Lights Indicates the port is successfully established.
Blink Indicates the Switch is actively sending or receiving data over that port.
10/100
LNK/ACT
Amber
Lights Indicates the port is successfully established.
Blink Indicates the Switch is actively sending or receiving data over that port.