User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
168
4.9.8 Neighbor MAC ID Settings
On this page. Neighbor MAC ID Settings is used for searching for switch MAC Address ID from each port of Managed PoE+
Switch, according to send period setting for sending out the neighbor information packets. The Managed PoE+ Switch will add
or update the MAC Address ID when receiving the neighbor information packets; also the switch neighbor MAC address ID
information can be obtained by using the UDP NetCMD tools. The Neighbor MAC ID Settings Configuration screen in Figure
4-9-28 is shown below.
Figure 4-9-28: Neighbor MAC ID Settings Configuration Page Screenshot
The page includes the following fields:
Object Description
• Status This column providesconfiguring enable or disable the Neighbor MAC ID
settings function.
• Send Period This column provides configuring Send Period settings; the default value is 3
and the available range is 1 to 65535. Unit is second.
• Aging Time This column provides configuring Aging Time settings; the default value is 6 and
the available range is
1
to
65535
. Unit is second.
• Neighbor MAC ID Information
• Port No. Display the per port list.
• MAC Add Display the MAC address from per port list.
• Aging Time Display the Aging time from per port list.
Buttons
: press this button to take effect.
: press this button to refresh current status.