User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
167
4.9.7 GVRP
On this page. GVRP (GARP VLAN Registration Protocol or Generic VLAN Registration Protocol) is a protocol that facilitates
control of virtual local area networks (VLANs) within a larger network. The GVRP Configuration screen in Figure 4-9-27
appears.
Figure 4-9-27: GVRP Settings Configuration Page Screenshot
The page includes the following fields:
Object Description
• GVRP Settings This column provides configuring enable or disable the GVRP function.
• Join Time This column provides configuring Join Time settings; the default value is 2. The
Join time must not be less than 2 seconds.
• Leave Time This column provides configuring Leave Time settings; the default value is 6.
The Leave time must not be less than 2 seconds.
• Leave All Time This column provides configuring Leave All Time settings; the default value is
20. The Leave All time must not be less than Leave time.
Button
: press this button to take effect.