User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
159
4.9.4 MLD Snooping
4.9.4.1 MLD Snooping Settings
This page allows you to configure the MLD Snooping settings for Managed PoE+ Switch as the screen in Figure 4-9-21
appears.
Figure 4-9-21: MLD Snooping Settings Configuration Page Screenshot
The page includes the following fields:
Object Description
• MLD Snooping State This column provides configuring enable or disable the MLD Snooping function.
• Version This column provides selecting the IGMP Snooping operation version; the
default version is MLDv2 and available options are MLDv1 and MLDv2.
• MLD Group Aged Out This column provides configuring enable or disable the MLD Group Aged Out
function.
• GMI (10-65535) This column provides configuring the value for Group Member Interval Time; the
default value is 100 seconds and the available range is 10 to 65535 seconds.
After the dynamic Group is established, the time is used to ask if there is
member.
• Router Aging Time
(10-65535)
This column provides configuring the value for Router Aging Time; the default
value is 100 seconds and the available range is 10 to 65535 seconds.
The time the dynamic Router Port exists, and if the Query packet is not
continuously received, the dynamic Router Port clears.
• MLD Immediate Leave This column provides configuring enable or disable the MLD Immediate Leave
function.
Button
: press this button to take effect.