User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
155
4.9.3.1 IGMP Snooping Settings
This page allows you to configure the IGMP Snooping settings for Managed PoE+ Switch as the screen in Figure 4-9-17
appears.
Figure 4-9-17: IGMP Snooping Settings Configuration Page Screenshot
The page includes the following fields:
Object Description
• IGMP Snooping State This column provides configuring enable or disable the IGMP Snooping
function.
• Version This column provides selecting the IGMP Snooping operation version; the
default version is IGMPv3 and available options are IGMPv1, IGMPv2 and
IGMPv3.
• IGMP Group Aged Out This column provides configuring enable or disable the IGMP Group Aged Out
function.
• GMI (10-65535) This column provides configuring the value for Group Member Interval Time; the
default value is 100 seconds and the available range is 10 to 65535 seconds.
After the dynamic Group is established, the time is used to ask if there is
member.
• Router Aging Time
(10-65535)
This column provides configuring the value for Router Aging Time; the default
value is 100 seconds and the available range is 10 to 65535 seconds.
The time the dynamic Router Port exists, and if the Query packet is not
continuously received, the dynamic Router Port clears.
• IGMP Immediate Leave This column provides configuring enable or disable the IGMP Immediate Leave
function.
Button
: press this button to take effect.