User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
150
This page allows you to configure the Trunk & Link Aggregation settings for Managed PoE+ Switch as the screen in Figure
4-9-12 appears.
Figure 4-9-12: Trunk & Link Aggregation Configuration Page Screenshot
The page includes the following fields:
Object Description
• Link Aggregation
Algorithm
This column provides configuring Link Aggregation Algorithm and default is
MAC Source, the available options are shown below:
Port
MAC Source
MAC Destination
MAC Source Destination
IP Source
IP Destination
TCP/UDP Destination Port
TCP/UDP Source Port
• Group
Display Trunk & Link Aggregation group information.
• Port Select
This column provides configuring and selecting the port for Trunk & Link
Aggregation.
• Status Display Trunk & Link Aggregation member port status.
• State This column provides configuring enable or disable the Trunk & Link
Aggregation function on specific port; the default mode is Disable.
• Trunk Type This column provides configuring and selecting the Trunk type for Trunk & Link
Aggregation function; the default mode is LACP and available options are
Static and LACP.
• Mode This column provides configuring and selecting the Trunk mode for Trunk & Link
Aggregation function; the default mode is Passive and available options are
Active
and
Passive
.
• Time Out This column provides configuring and selecting the Time Out for Trunk & Link
Aggregation function; the default mode is Short and available options are Short
and Long.
Button
: press this button to take effect.