User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
127
4.8.2.2 Port-MAC-IP Entry Setting
This page allows you to configure the Port-MAC-IP Entry settings for Managed PoE+ Switch as the screen in Figure 4-8-4
appears.
Figure 4-8-4: Port-MAC-IP Entry Setting Configuration Screen Page Screenshot
The page includes the following fields:
Object Description
Create IMP Entry
• IPv4/IPv6 This column allows user to establish the IMP Entry as IPv4 or IPv6, and enter IPv4 or
IPv6 IP Address in the right space.
IMP Entry Management
• IP This column provides corresponding to the selected IMP Entry IP Address.
• Check Port This column provides configuring enable or disable the check source port compliance.
• Port This column provides selecting the port for this IP address.
• Check MAC This column provides configuring enable or disable the check source MAC compliance.
• MAC
This column provides configuring the corresponding source MAC for this IP address.
• Action This column provides configuring the corresponding action filter / priority when the
condition is met.
• Priority This column provides configuring the queue for this IMP Entry when the action is
selected as priority; the available range is 0 to 7.
IP Table Monitor
• IP
Display the IPv4 or IPv6 address.
• Type
Display the type information.