User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
125
4.8.2 Port-MAC-IP Binding
The Port-MAC-IP Binding configuration provides the IPv4/IPv6 for basic security protection and filtering by checking the source
IP address of the packet. Each port can be configured on the page to check whether the source IP address and the source port
match. The matching packets are further acted by the two filtering modes selected.
The Port-MAC-IP Binding configuration includes the Port-MAC-IP Port Setting, Port-MAC-IP Entry Setting and DHCP Snooping
Entry Setting. Table 4-8-2 shows the items of Port-MAC-IP Binding functions.
Security Configuration
Item Description
Port-MAC-IP Port Setting
Configure and display Port-MAC-IP Port settings on this web page.
Port-MAC-IP Entry Setting
Configure and display Port-MAC-IP Entry settings on this web page.
DHCP Snooping Entry Setting
Configure and display DHCP Snooping Entry settings on this web page.
Table 4-8-2: Descriptions of Port-MAC-IP Binding Configuration
4.8.2.1 Port-MAC-IP Port Setting
This page allows you to configure the Port-MAC-IP Port settings for Managed PoE+ Switch as the screen in Figure 4-8-3
appears.
Figure 4-8-3: Port-MAC-IP Port Setting Configuration Screen Page Screenshot