User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
117
• Source IP Address Configure the Source IP Address.
• Source IP Mask Configure the Source IP Mask and the available options are shown below:
255:255:255:255
255:255:255:240
255:255:255:0
255:255:240:0
255.255:0:0
255.0.0.0
240.0.0.0
• Destination IP Address Configure the Destination IP Address.
• Destination IP Mask Configure the Destination IP Mask and the available options are shown below:
255:255:255:255
255:255:255:240
255:255:255:0
255:255:240:0
255.255:0:0
255.0.0.0
240.0.0.0
• Source Port Configure the Source Port of Low and High.
• Destination Port Configure the Destination Port of Low and High.
• VID Configure the VID and the available range is 1-4094.
• CoS Configure the CoS and the vailable range is 0-7.
• Ethernet Port Configure the Ethernet Type.
• TCP Flag Configure the TCP Flag and available options are shown below:
URG/0/1
ACK/0/1
PSH/0/1
RST/0/1
SYN/0/1
FIN/0/1
• DSCP Configure the DSCP and the available range is 0-63.
• IP Protocol Configure the IP Protocol.
• Ingress Port Select the specific port as Ingress port.
• Action Select the action and the available options are shown below:
Drop
Type 1
Type 2
Type 3
Type 4
Button
: press this button to take effect.