User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
115
4.7.2.4 IPv6
The Access Control List configuration includes the function that is based on IPv6 address as the screen in Figure 4-7-6 appears.
Figure 4-7-6: ACL Profile List-IPv6 Configuration Page Screenshot
The page includes the following fields:
Object Description
• Name
Display the ACL profile name.
• Source IPv6 Address
Configure the Source IPv6 Address.
• Source IPv6 Mask
Configure the Source IPv6 Mask and the available options are shown below:
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:0000:0000
FFFF:FFFF:FFFF:0000:0000:0000:0000:0000
FFFF:0000:0000:0000:0000:0000:0000:0000
• Destination IPv6 Address
Configure the Destination IPv6 Address.
• Destination IPv6 Mask
Configure the Destination IPv6 Mask and the available options are shown
below:
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:0000:0000
FFFF:FFFF:FFFF:0000:0000:0000:0000:0000
FFFF:0000:0000:0000:0000:0000:0000:0000
• Ingress Port
Select the specific port as Ingress port.
• Action
Select the action and the available options are shown below:
Drop
Type 1
Type 2
Button
: press this button to take effect.