User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
111
4.7.2.1 MAC
The Access Control List configuration includes the function that is based on MAC address as the screen in Figure 4-7-3
appears.
Figure 4-7-3: ACL Profile List-MAC Configuration Page Screenshot
The page includes the following fields:
Object Description
• Name Display the ACL profile name.
• Source MAC Address Configure the Source MAC Address.
• Source MAC Mask Configure the Source MAC Mask and the available options are shown below:
FF:FF:FF:FF:FF:FF
FF:FF:FF:00:00:00
FF:FF:00:00:00:00
• Destination MAC Address Configure the Destination MAC Address.
• Destination MAC Mask Configure the Destination MAC Mask and the available options are shown
below:
FF:FF:FF:FF:FF:FF
FF:FF:FF:00:00:00
FF:FF:00:00:00:00
• VID Configure the VID and the available range is 1-4094.
• CoS Configure the CoS and the available range is 0-7.
• Ethernet Type Configure the Ethernet Type.
• Ingress Port Select the specific port as Ingress port.
• Action Select the action and the available options are shown below:
Drop
Type 1
Type 2
Button
: press this button to take effect.