User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
106
4.6.8 DSCP-based Priority
This page allows you to configure the DSCP-based Priority settings for Managed PoE+ Switch as the DSCP-based Priority
screen in Figure 4-6-8 appears.
Figure 4-6-8: DSCP-based Priority Configuration Page Screenshot
The page includes the following fields:
Object Description
• Priority For DSCP Not
Match
Provide two options for selection.
Regard as low priority (priority 0)
Ignore IP priority (priority will according to tag/port)
• IP ToS/DSCP CoS Base
Priority
Provide three functions for setting.
DSCP List: provide DSCP1 to DSCP8 options to choose.
Value(0-63):allow input the value range from 0 to 63.
Priority: provide Q0 to Q7 options to choose.
• List
Display DSCP1 to DSCP8.
• Value
Display the value setting of per DSCP1 to DSCP8.
• Priority
Display the priority setting of per DSCP1 to DSCP8.
Button
: press this button to take effect.