User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
104
4.6.6 Class of Service
This page allows you to configure the QoS Class of Service settings for all switch ports as the QoS Class of Servic screen in
Figure 4-6-6 appears.
Figure 4-6-6: QoS Class of Service Configuration Page Screenshot
The page includes the following fields:
Object Description
• Port Selection Select specific port for QoS Class of Service settings.
• ACL
Enable or disable the ACL function for specific port.
Also display per port ACL status.
• IGMP
Enable or disable the IGMP function for specific port.
Also display per port ICMP status.
• IP Addr
Enable or disable the IP Address function for specific port.
Also display per port IP Address status.
• MAC Addr
Enable or disable the MAC Address function for specific port.
Also display per port MAC Address status.
• VID
Enable or disable the VID function for specific port.
Also display per port VID status.
• TCP/UDP Port
Enable or disable the TCP/UDP Port function for specific port.
Also display per port TCP/UDP Port status.
• DSCP
Enable or disable the DSCP function for specific port.
Also display per port DSCP status.
• 802.1p
Enable or disable the 802.1p function for specific port.
Also display per port 802.1p status.
• Physical Port
Select Queue ratio for specific port and the available range is Queue0-Queue7.
Also display per port Queue status.
• Port No.
Display per port list.