User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
103
4.6.5 QoS Remap
This page allows you to configure the QoS Remap settings for all switch ports as the QoS Remap screen in Figure 4-6-5
appears.
Figure 4-6-5: QoS Remap Configuration Page Screenshot
The page includes the following fields:
Object Description
• Port Selection Select specific port for QoS Remap settings.
• Mode
Set operation mode for specific port and the available options are shown as
below:
Tx&Rx
Tx
Rx
• Q0 ~Q7
Set each queue to the queue number of QoS Remap.
• Port No.
Display per port list.
• TX Remap Q0-Q7
Display per port queue number of Q0 to Q7 from TX Remap.
• RX Remap Q0-Q7
Display per port queue number of Q0 to Q7 from RX Remap.
Button
: press this button to take effect.