User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 PoE Configuration
- 4.4 Basic Configuration
- 4.5 VLAN Configuration
- 4.6 QoS Configuration
- 4.7 ACL Configuration
- 4.8 Security
- 4.9 Advanced Features
- 4.10 Monitoring
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 7. SWITCH OPERATION
- 8. Power over Ethernet Overview
- 9. TROUBLESHOOTING
- APPENDEX A: Networking Connection
- APPENDIX B: GLOSSARY
User’s Manual of FGSW-Series
101
4.6.3 QoS Mode Set
This page allows you to configure the QoS mode settings for Managed PoE+ Switch as the QoS mode settings screen in Figure
4-6-3 appears.
Figure 4-6-3 : QoS Mode Set Configuration Page Screenshot
The page includes the following fields:
Object Description
• Group Display Group A and Group B.
• Queue Mode Select the Queue Mode for QoS and the available options are shown below:
First-In-First-Out
WRR/WFQ/Bwassure/Bwlimit/TWRR
SPx1 WRR/WFQ/Bwassure/Bwlimit/TWRRx7
SPx2 WRR/WFQ/Bwassure/Bwlimit/TWRRx6
SPx4 WRR/WFQ/Bwassure/Bwlimit/TWRRx4
SPx8
• Queue Method Select the Queue Method for QoS and the available options are shown below:
WRR
WFQ
Bwassure
Bwlimit
TWRR
• Queue Ratio (0-255) Set Queue Ratio for each mode and the available range is 0-255.
• Queue Maximum
Bandwidth (0-255)
Set Queue maximum bandwidth and the available range is 0-255.
• Unit (BW Throttle
Period/TWRR Tickle
Unit)
Set Queue Ratio Unit for each mode and the available options are shown below:
64Kbps/51.2ms
1Mbps/3.1ms
2Mbps/1.55ms
4Mbps/0.82ms
Button
: press this button to take effect.