- Planet WAN Router User's Manual

38
The frame relay switch, which is responds one or more LMI types. There are three different
LMI types: cisco, ansi and q933a.
encapsulation frame-relay – encapsulation frame relay type on serial interface
frame-relay map ip protocol address dlci [broadcast | gateway-down | interface-down |
payload-compression] – configure static address mapping
frame-relay dlic-group – assign DLCI to some group
frame-relay fist-dlic – the number of first dlci (16-1007)
frame-relay intf-type – configure frame-relay interface type (dec, dte)
frame-relay inverse-arp – Enable/Disable inverse ARP
frame-relay lapf – set lapf parameter
frame-relay lmi-n391 – set the counter on PVC status enquiry message
frame-relay lmi-n392 – set the LMI error threshold
frame-relay lmi-n393 – set LMI monitor event counter
frame-relay lmi-t391 – set LMI T391 timer (0-4294967295)
frame-relay lmi-t392 – set DCE request confirm timer (3-30)
frame-relay lmi-type – set LMI type (ansi, cisco, q933a)
frame-relay local-dlci – set local dlci
frame-relay num-dlci – Assign the frame relay DLCI number