- Planet WAN Router User's Manual

15
convergence. Whenever a router changes the metric of a route, it is required to send update
messages almost immediately
4.1.1.5 RIP Command
router rip – enable rip in global configuration mode
version - To specify a RIP version used globally by the router (version 1 and 2)
auto-summary – enable automatic network number summarization.
Network – Enable routing on an IP network
Neighbor – specify a neighbor router
Bind-interface – Enable RIP protocol on some interface
Default-metric – set metric of redistributed routes
Distance – define an administrative distance
Distribute-list – Filter networks in routing updates
Offset-list –To add an offset to incoming and outgoing metrics to routes learned via RIP
Passive-interface - To disable sending routing updates on an interface.
Redistribute - To redistribute routes from one routing domain into another routing domain.
Timers – adjust routing timers
Validate-update-source - Perform sanity checks against source address of routing updates
Show ip route – show all routes learned through RIP
Debug ip rip - To show RIP operation information and update messages sent or received by
routers.
The difference between RIPV1 and RIPV2 is RIPV2 is not a new
protocol; rather it is RIPV1 with some extensions. The most of
important extensions in RIPV2 is addition of a Subnet mask field to
the routing update entries, enabling the use of VLSM.
Example of RIP
ERT_805# show run