- Planet WAN Router User's Manual

11
telnet. If configures like below, the system will only ask for password when anyone access. For
example set the password as “1234”.
ERT805> enable
ERT805# config t
ERT805(config)# enable password 1234
ERT805(config)#line vty 0 4
ERT805(config-line)# login
ERT805(config-line)# password cisco
ERT805(config-line)# exi
ERT805(config)# exit
ERT805#
The password is set by the command “password” in vty and has no concern with what have
been configured above by the command username. The following example shows the result
that configure on above.
Router Software Version 4.2c on Hex_1f73 (3805a)
User Access Verification
Password:
ERT_805> enable
Password:
ERT_805#
The other method is force the network user to verify his username and password. For example
ERT805# config t
Enter configuration commands, one per line. End with CNTL/Z.
ERT805(config)# username rr password cisco
ERT805(config)# line vty 0 5
ERT805(config-line)# login local
ERT805(config-line)# exit
ERT805(config)# exit
ERT805#
The following example shows the result that configure on above: